How to Plan a Striped Nursery Wall with Stripes Away Wallpaper
By Organic Baby & Toddler Clothes | Nursery & Decor | Pehr | Published: 2026-11-01
Category: How-to Guides
Plan a striped nursery accent wall step by step, from measuring and layout to hanging peel-and-stick Stripes Away wallpaper in Marigold without commitment.
Quick answer
Plan the stripe layout and wall prep before you peel anything: measure the accent wall, choose a stripe direction, mark a center line, then hang Stripes Away removable wallpaper from the top down, smoothing as you go.
Why a striped accent wall works in a nursery
A single striped wall adds rhythm without overwhelming a small room, and it gives you a clear place to stop. Stripes can make a low ceiling feel taller when run vertically, or widen a narrow room when run horizontally. Decide which effect you want before you buy, because the direction changes how you measure and cut.
Peel-and-stick wallpaper suits nurseries because it is removable, so you can change the look as your child grows. That flexibility matters more than a permanent install if you are renting or plan to repaint soon.
Choose the stripe direction and scale
Vertical stripes draw the eye up and work well behind a crib or dresser. Horizontal stripes can make a small wall feel wider but may compete with shelving and art. Keep the scale in mind: wide stripes feel calmer, while narrow stripes feel busier. If the room already has patterned bedding or a rug, let the wall be the quieter element.
Marigold is a warm, saturated tone, so it pairs best with neutral furniture, white trim, and simple textiles. If you want a softer look, use it on one wall rather than all four.
Prep the wall before you peel
Wallpaper adheres best to clean, smooth, dry surfaces. Wash the wall with a mild degreaser, rinse, and let it dry completely. Fill nail holes and sand them flush, then wipe away dust. Freshly painted walls should cure fully before you apply anything, so check the paint can for the recommended wait time.
Skip this step and you may see bubbles, curling edges, or a finish that pulls away when you remove the paper. Textured walls and heavily soiled surfaces are the most common reasons peel-and-stick wallpaper fails.
Step-by-step: hang a striped nursery accent wall
- Measure the wall and calculate panels: Measure the width and height of the accent wall. Divide the width by the stripe width you want, then round up to the nearest whole stripe so the pattern ends evenly at both corners. Add 10% to your panel count for trimming and mistakes. Write the panel count and stripe width on painter's tape so you do not have to recalculate mid-install.
- Mark a center line and layout: Find the wall's center and draw a vertical plumb line with a level. Use that line to position your first panel, then mark each stripe edge lightly with a pencil. Check the marks against the level before you peel any backing. A crooked first panel throws off every stripe after it, so verify the center line twice.
- Cut panels with extra allowance: Unroll the wallpaper and cut panels about 2 inches longer than the wall height. Label the back of each panel with its intended position so the pattern stays consistent when you hang them. Cutting too short is the most common mistake; the extra allowance lets you trim cleanly at the ceiling and baseboard.
- Peel and press from the top down: Peel back a few inches of backing at the top, align the panel to your center line, and press it into place. Work downward in short sections, smoothing with a felt squeegee as you go. Keep the panel edge on your pencil mark. Do not peel the entire backing at once; small sections keep the panel manageable and reduce bubbles.
- Trim edges and repeat: Use a sharp utility knife and a straightedge to trim the excess at the ceiling, baseboard, and corners. Change the blade often so it cuts cleanly instead of tearing. Hang the next panel edge-to-edge, matching the stripe spacing. A dull blade leaves ragged edges that show up close, so keep spare blades on hand.
- Inspect and smooth: Step back and check for bubbles, lifted edges, and alignment. Press small bubbles out toward the nearest edge with your squeegee. If a bubble will not move, prick it with a pin and smooth it flat. Check the wall in daylight before you put the furniture back; low light hides misaligned stripes.
Product facts
- Chasing Paper X Pehr Wallpaper - Stripes Away Marigold: Peel-and-stick design made for easy application and removal. You can hang it without paste and remove it later, which suits a nursery you may redecorate as your child grows.
Chasing Paper X Pehr Wallpaper - Stripes Away Marigold
